![]() Then each time you want to read a value you write a value to a different register to tell the card what channels (up to two at a time) to scan and which 3x register to put the each value into. This usually consisted of writing values into specific 4x registers to tell the card what type of analog signal was going to be seen on each channel as well as what channels will be active (this only had to be done once at each power up). When using the original 984LL software some Modicon analog cards needed to be configured before you could read them. I am not familiar with the software or the specific card you are using, so I don't know the actual commands. Jrim Software Proxy Multiply V1 0 0 8 Lz0 30 000 Proxies Cracked. The program installs politely but leaves a desktop icon.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |